Motorola SBG9000 with USBJTAG

Salu2 Hello to everyone: little brother who has integrated the router SBG900 is the echo I do not have as many loses kiss when you edit the router but still have a tutorial here: Programming Motorola SBG9000 with USBJTAG nt, NOTE: This document is made for educational purposes, any other use and / or other purposes is the sole responsibility of the user.
The cable modem must be disconnected from electricity, when uncovered and also when
USBJTAG connect.

1 .- off all (light and PC)
2 .- open the SBG900
3 .- connect the SBG900 USBJTAG NT
4 .- NT connect to the PC USBJTAG
5 .- connect the SBG900 to light
6 .- Program

- Baja Firm_sgb900_BPI_OK_Consola flash, this has enabled telnet, thus it
can change the mac with the commands.
.- Subes full flash with the cable USBJTAG (selects first and foremost in the model SBG900
USBJTAG your program in "Tools" - "Settings")
detect
9fc00000 ldram
400,000 9fc00000 program
9fc00000 cmpram 400,000

First identified as modem SBG900 opens:


1 .- It has a screw in the upper back, 2 .- take off the label.


3 .- Remove the tabs careful not to break.


We revealed the equipment carefully to avoid breaking the antenna.


Already open, we seek to connect the USBJTAG nt.


Identify the pin 1 and connect the USBJTAG, red is the pin1,
USBJTAG not connected to anything when you connect the SBG900 (the usb jtag should not be
connected to the CPU)
SBG900 team should not be connected to the light when you connect the USBJTAG


Already connected the computer proceed to the software.

Aa USBJTAG connect the PC (for this and must be connected to the SBG900)
Then connect the modem to light
open the program usbjatg


Open the program and see if the USBJTAG detected as connected, configured to do
the SBG900 which is the model we will use


We selected the model


We write in the box below and we detect enter (my details are fuzzy to avoid misunderstanding)